Braun Wet & Dry Electric Shaver 9280CC Instruction Manual
Content
Introduction
The Braun Wet & Dry Electric Shaver 9280CC combines cutting-edge technology with user-friendly design to deliver an exceptional shaving experience. Featuring five specialized shaving elements, it captures more hair in a single stroke, reducing the number of passes needed and minimizing skin irritation. Its waterproof design allows for both wet and dry shaving, while the included Clean & Charge station ensures optimal hygiene and maintenance. This premium shaver is priced at $169, making it a worthwhile investment for a close, comfortable shave.
Accessories
Braun recommends changing your shaver’s Foil & Cutter cassette every 18 months to maintain your shaver‘s maximum performance. Available at your dealer or Braun Service Centres:
- Foil & Cutter cassette: 92S/92B
- Cleaning cartridge Clean & Charge Station: CCR
- Braun Shaver cleaner spray
Specifications
- Wet & Dry shaving capability
- Intelligent Sonic Technology with 40,000 cross-cutting actions per minute
- HyperLift Trimmer for capturing and cutting flat-lying hairs
- Direct & Cut Trimmer for precision trimming
- Charging dock with cleaning and lubrication functions
- Lithium-ion battery with up to 50 minutes of cordless use
- Travel lock and travel pouch included
- Waterproof design for easy cleaning under running water
Read these instructions completely, they contain safety information. Keep them for future reference.
Warning
- Your appliance is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk of an electric shock. Only use the special cord set provided with your appliance.
- If the appliance is marked Braun power supply coded 492-XXXX.
- This appliance is suitable for cleaning under running water and use in a bathtub or shower. For safety reasons, it can only be operated cordless.
- Do not shave with a damaged foil or cord.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the safe use of the appliance and understand the hazards involved.
- Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 years and supervised.
Clean & Charge Station (not with all models)
- To prevent the cleaning fluid from leaking, ensure that the Clean & Charge Station is placed on a flat surface.
- When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge.
- Do not place the station inside a mirror cabinet, nor place it on a polished or lacquered surface.
- The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition.
- Do not expose to direct sunlight and cigarette smoking nor store it over a radiator.
- Do not refill the cartridge and use only original Braun refill cartridges.
Overview Shaver
- Foil & Cutter cassette
- Cassette release buttons
- MultiHeadLock switch
- On/off switch
- Shaver display (design can differ)
- Long hair trimmer
- Shaver-to-station contacts
- Release button for long hair trimmer
- Shaver power socket
- Special cord set (design can differ)
- Charging stand (design can differ)*
Travel case
* not with all modelsClean & Charge Station
(not with all models)
The Clean & Charge Station has been developed for cleaning, charging, lubricating, disinfecting, drying and storing your Braun shaver.- Station power socket
- Lift button for cartridge exchange
- Station-to-shaver contacts
- Clean & Charge Station display
- Level indicator
- Status light
- Cleaning program indicators
- Start button
Cleaning cartridge
First use and Charging
Connect the shaver to an electrical outlet by snapping the special cord set (10) into the power socket (9) / the charging stand (10a) or for cc models via the Clean & Charge Station (see Chapter «Clean & Charge Station»).
Charging and basic operating information
- When charging for the first time, charge continuously for 1 hour.
- A full charge provides up to 50 minutes of cordless shaving time. This may vary according to your beard growth and environmental temperature.
- The recommended ambient temperature for charging is 5 °C to 35 °C. The battery may not charge properly or at all under extreme low or high temperatures.
- The recommended ambient temperature for shaving is 15 °C to 35 °C.
- Do not expose the appliance to temperatures higher than 50 °C for extended periods of time.
- When the shaver is connected to an electrical outlet, it may take some minutes until the display illuminates.
Braun Wet & Dry Electric Shaver 9280CC Display
Charge status
The shaver display (5) shows the charge status of the battery when connected to an electrical outlet:
- During charging the respective battery segment will blink.
- When fully charged all battery segments will light up for a few seconds then the display turns off.
Low charge
The low-charge light flashes red when the battery is running low. You should be able to finish your shave. With switching off the shaver a beep sound reminds of the low charge status.
The last 9 minutes of remaining shaving time are displayed in digits (depending on your model / display).
Cleaning status (only models with Clean & Charge Station)
The cleaning indicator lights up when the shaver needs to be cleaned in the Clean & Charge Station.
Travel lock
The lock symbol lights up when the shaver has been locked to avoid unintended starting of the motor (e.g. for storing in a suitcase).
Description
The Braun Wet & Dry Electric Shaver 9280cc features a sleek and ergonomic design, making it comfortable to hold and maneuver. The shaver head is equipped with advanced trimmers that capture and cut hairs in one stroke, reducing the need for multiple passes. The intelligent sonic technology adjusts to the density of your beard, ensuring an optimal shave every time.
The included charging dock not only charges the shaver but also cleans and lubricates it, extending the lifespan of the blades. The lithium-ion battery provides sufficient power for several shaves on a single charge, and the travel lock ensures safe transportation.
Using the shaver
(see fig. A)
Press the on/off switch (4) to operate the shaver.
Tips for a perfect dry shave
- Always shave before washing your face.
- At all times, hold the shaver at the right angle (90°) to your skin.
- Stretch your skin and shave against the direction of your beard growth.
MultiHeadLock switch (headlock)
- To shave hard-to-reach areas (e.g. under the nose) slide the MultiHeadLock switch (3) down to lock the shaver head. The shaver head can be locked in five positions.
- To change position, move the shaver head with your thumb and forefinger back or forth. It will automatically click into the next position.
- Only models with Clean & Charge Station: For automatic cleaning in the Clean & Charge Station the head lock should be released.
Long hair trimmer
To trim sideburns, moustache or beard press the release button (8) and slide the long hair trimmer (6) upwards.
Travel lock
Activation: By pressing the on/off switch (4) for 3 seconds the shaver is locked.
This is confirmed by a beep sound and the lock symbol in the display. Afterwards the display turns off.
Deactivation: By pressing the on/off switch for 3 seconds the shaver is unlocked again.
Setup Guide
To operate the Braun Wet & Dry Electric Shaver 9280cc,
- Start by charging the device using the provided charging dock.
- Once charged, simply turn on the shaver and adjust the trimmer settings as needed.
- For wet shaving, apply your preferred shaving cream or gel before shaving. For dry Sshaving, ensure your skin is clean and dry.
Manual cleaning of the shaver
(see fig. B/C)
Cleaning under running water
- Switch on the shaver (cordless) and rinse the shaver head under hot running water until all residues have been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
- Next, switch off the shaver, press the release buttons (2) to remove the Foil & Cutter cassette (1) and let it dry completely.
- If you regularly clean the shaver under water, then once a week apply a drop of light machine oil (not included) on top of the Foil & Cutter cassette and the long hair trimmer.
The shaver should be cleaned after each foam usage.
Cleaning with a brush
Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. Do not clean the cassette with the brush as this may damage it!
The Foil & Cutter cassette can be attached either way. There is no impact on the shaving performance.
Installing the Clean & Charge Station
(see fig. D)
- Press the lift button (13) at the rear side of the Clean & Charge Station to lift up the housing.
- Hold the cleaning cartridge (17) down on a flat, stable surface (e.g. table).
- Carefully remove the lid from the cartridge.
- Slide the cartridge from the rear side into the base of the station until it snaps into place.
- Slowly close the housing by pushing it down until it locks.
- Connect the station to an electrical outlet by snapping the special cord set (10) into the power socket (12).
Charging the shaver in the Clean & Charge Station
- Insert the shaver head with the front showing and release the head lock into the cleaning station.
Important: The shaver needs to be dry and free from any foam or soap residue!
The contacts (7) on the back of the shaver need to align with the contacts (14) in the station. Push the shaver in the correct position. A beep sound confirms that the shaver sits properly in the station. Charging will start automatically.
Cleaning the shaver
- When the cleaning indicator lights up in the shaver display, insert the shaver into the Clean & Charge Station, as described above and press the start button (16).
- The hygiene status will be analyzed and is shown by the cleaning program indicators (15c) in the Clean & Charge Station display.
- If status light (15b) does not shine (Clean & Charge Station switches to stand-by after ca. 10 minutes), press start button twice. Otherwise cleaning will not start. For best shaving results, we recommend cleaning after each shave.
- The cleaning process consists of several cycles, in which cleaning fluid is flushed through the shaver head. Depending on the program selected, the cleaning time takes up to 3 minutes, followed by an active drying phase of about 40 minutes, during which a fan is running.
- Afterwards charging will resume, which is indicated in the shaver display. When the shaver is fully charged the display turns off.
Cleaning programs
- short economical cleaning
- normal level of cleaning
- high intensive cleaning
Removing the shaver from the Clean & Charge Station
(see fig. E)
- Hold the Clean & Charge Station with one hand and tilt the shaver slightly to the front to release it.
Cleaning Cartridge
(see fig. F)
- When the level indicator (15a) lights up permanently red, the remaining fluid in the cartridge is sufficient for about 3 more cycles.
- When the level indicator blinks red, the cartridge needs to be replaced (about every 3 weeks when used daily).
After having pressed the lift button (13) to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
The hygienic cleaning cartridge contains alcohol or isopropanol (specification see cartridge), which once opened will naturally evaporate slowly. Each cartridge, if not used daily, should be replaced after approximately 8 weeks to ensure optimal disinfection. The cleaning cartridge also contains lubricants for the shaving system, which may leave residual marks on the outer foil frame and the cleaning chamber of the Clean & Charge Station. These marks can be removed easily by wiping gently with a damp cloth.
Braun Wet & Dry Electric Shaver 9280CC Troubleshooting
Problem: | Possible reason: | Remedy: |
SHAVER | ||
Shaver does not startwhen pressing the start button. |
|
|
Shaver does not charge completely and keeps blinking. | Ambient temperature is out of valid range. | Recommended ambient temperature for charging is 5 °C to 35 °C. |
Charging does not start when connected to power socketor put in charging stand / Clean&Charge Station. |
|
|
Unpleasant smell from the shaver head. |
|
|
Battery performance dropped significantly. |
|
|
Shaving performance dropped significantly. |
|
|
Shaver turns off with fully chargedbattery. | Foil and cutter are worn which requires more power than the motor can deliver. The appliance turns off. |
|
Shaver head is damp. |
|
|
CLEAN & CHARGE STATION
Cleaning does not startwhen pressing the start button. |
|
|
Increased consumption of cleaning fluid. | Drain of the Clean&Charge Station is clogged. |
|
Guarantee
We grant a 2-year guarantee on the product commencing on the date of purchase. Within the guarantee period we will eliminate any defects in the appliance resulting from faults in materials or workmanship, free of charge either by repairing or replacing the complete appliance at our discretion.
Braun Wet & Dry Electric Shaver 9280CC Pros & Cons
Pros
- Excellent shaving performance in both wet and dry conditions
- Advanced trimmers for capturing flat-lying hairs
- Convenient charging dock with cleaning and lubrication functions
- Long-lasting lithium-ion battery
- Ergonomic design for comfortable handling
Cons
- Pricier compared to other electric shavers on the market
- Some users may find the cleaning process slightly complex
- Replacement parts can be expensive
Customer Reviews
Customers have praised the Braun Wet & Dry Electric Shaver 9280CC for its superior shaving performance and ease of use. Many users appreciate the convenience of the cleaning dock and the long battery life. However, some have noted that the price is on the higher side and that replacement parts can be costly.
Most Common Complaints
- High cost of replacement blades
- The complex cleaning process for some users
Faqs
What is the primary difference between the Braun Electric Shaver and other models in the Series 9 lineup?
Can I use the Braun shaving other body parts?
How often should I clean and maintain my Electric Shaver 9280cc?
Is the Wet & Dry suitable for men with sensitive skin?
Can I travel with the Braun Shaver?
How long does the battery last on a single charge?
What are the benefits of using the charging dock that comes with the Braun 9280cc?
Can I shave my beard while it is still wet from the shower?
How do I replace the blades of my Braun Shaver?
Is the Wet & Dry waterproof?
Leave a Comment