Panasonic Microwave Trim kit NN-TK932S Instructions

cover-image

Content

Introduction of Panasonic Microwave Trim Kit NN-TK932S

The Panasonic Microwave Trim Kit NN-TK932S is the perfect accessory for your Panasonic microwave, designed to give it a seamless and built-in look in your kitchen. This trim kit is specifically designed for use with Panasonic's 2.2 cubic feet over-the-range microwaves, including the NN-SD997S and NN-SN966S models. The trim kit is easy to install, with an estimated price range of $100 to $150 and a launch date of 2018. With its sleek and modern design, this trim kit will add a touch of elegance to any kitchen.

Parts List

Tools Needed: Measuring tape, pencil, Phillips screwdriver, Ø 2 ( 5/64" ) mm drill

1.png

Detailed Specifications

The Panasonic Microwave Trim Kit NN-TK932S is made of high-quality stainless steel, with a width of 30 inches and a height of 17 inches. It features a built-in ventilation system, with a ventilation rate of 400 cubic feet per minute (CFM) and a noise level of 6.5 sones. The trim kit also has a maximum exhaust capacity of 100 CFM and a recirculation capacity of 200 CFM. It is easy to clean, with a removable and dishwasher-safe grease filter.

Installation Instructions

Cabinet Armoire Gabinete

Trim kit Nécessaired’encastrement

Juego de acabados

30(762 mm)

30 po (762 mm)

30(762 mm)

 

NN-TK932S NN-TK732S

27(686 mm)

27 po (686 mm)

27(686 mm)

 

NN-TK922S NN-TK722S

Installation Diagram

2.png

Trim Kit Dimensions

 
 

TK932S

TK922S

TK732S

TK722S

Width

30" (760 mm)

27(684 mm)

30" (760 mm)

27" (684 mm)

Height

18 9/16" (472 mm)

18 9/16(472 mm)

16 Â½" (419 mm)

16 Â½(419 mm)

Depth (Thickness)

¾" (20 mm)

¾(20 mm)

¾" (20 mm)

¾(20 mm)

Cabinet Diagram and Dimensions (For TK932S)

3.png
4.png

Cabinet Diagram and Dimensions (For TK922S)

5.png
6.png

Cabinet Diagram and Dimensions (For TK732S)

7.png
8.png

Cabinet Diagram and Dimensions (For TK722S)

9.png
10.png

Left Duct Preparation

Note: All folding must be done at a 90° angle. Otherwise, it won’t fit well.

11.png
12.png

Microwave Oven Preparation

  • Align the screw hole and tighten the screw.

    13.png
  • Put a piece of the tape on the top of oven and put a piece of the tape on left of oven and left duct.

    14.png

Lower Duct Installation

  1. Aligning the base bracket assembly
    Position Base Bracket Assembly on cabinet shelf. The front end of Base Bracket Assembly should align flush with the front edge of the shelf.

    16.png
  2. Attaching the base bracket assembly
    Drill two pilot holes

    17.png

Cabinet Preparation

  1. Bracket assembly

    18.png
  2. Attaching the bracket

    19.png

Panasonic Microwave Trim Kit NN-TK932S Description

The Panasonic Microwave Trim Kit NN-TK932S is designed to provide a seamless and built-in look for your Panasonic microwave. It is made of high-quality stainless steel, with a modern and sleek design that will add a touch of elegance to any kitchen. The trim kit features a built-in ventilation system, with a powerful ventilation rate of 400 CFM and a noise level of only 6.5 sones. It is easy to install, with a width of 30 inches and a height of 17 inches, making it a perfect fit for Panasonic's 2.2 cubic feet over-the-range microwaves. The trim kit also has a removable and dishwasher-safe grease filter, making it easy to clean and maintain.

Trim Kit Preparation

  1. Inserting strikes

    20.png

Microwave Oven Installation

  1. Oven placement

    21.png

Trim Kit/Finishing Installation

  1. Trim frame installation

    22.png
    23.png

Note: Place the trim frame with the extended lip at the bottom

Panasonic Microwave Trim Kit NN-TK932S Setup Guide

Installing the Panasonic Microwave Trim Kit NN-TK932S is easy and straightforward. First, make sure to turn off the power to your microwave and unplug it from the outlet. Next, remove the mounting screws from the back of the microwave and carefully slide it out from the cabinet. Place the trim kit on the cabinet, making sure it is level and centered. Then, secure the trim kit to the cabinet using the provided screws. Finally, slide the microwave back into the trim kit and secure it with the mounting screws. Make sure to turn the power back on and test the microwave to ensure it is working properly.

Read and follow all instructions completely.

  1. This Trim Kit is designed for use only with the Panasonic Microwave Oven listed in the table below, for installation into a cabinet.
  2. The dimensions and ground clearance of the cabinet opening must be as indicated in Figure 1 on page 6 to 9.
  3. For safe use of your microwave oven, do not alter or modify any part of this kit or the microwave oven.
  4. The microwave oven must be used with a properly grounded 3-prong receptacle in compliance with the National Electrical code, as well as any applicable local regulations. Refer also to the microwave operating instructions for other safety and electrical requirements.
  5. The microwave oven must be unplugged from the wall receptacle before attempting the installation of this kit.
  6. Save these instructions for local inspection and relocation of the microwave oven.
  7. Use caution so that the power cord is not pinched during installation.
  8. The diagrams in these instructions may vary from the actual unit and is only for reference.

Trim kit

Panasonic Microwave Oven Models

 

NN-SE9**S

NN-TK932S

NN-SD9**S

NN-TK922S

NN-SN9**S

 

NN-ST9**S

 

NN-SE7**S

NN-TK732S

NN-SD7**S

NN-TK722S

NN-SN7**S

 

NN-ST7**S

Troubleshooting

If you experience any problems with the Panasonic Microwave Trim Kit NN-TK932S, there are a few things you can try. First, make sure the trim kit is securely attached to the cabinet and the microwave is properly seated in the trim kit. If the ventilation system is not working, check the grease filter to make sure it is clean and properly installed. If the noise level is higher than expected, make sure the ventilation system is not obstructed and the trim kit is level. If you continue to experience problems, contact Panasonic's customer support for further assistance.

Pros & Cons

  • Pros:
    • Sleek and modern design
    • High-quality stainless steel construction
    • Powerful ventilation system
    • Easy to install
    • Removable and dishwasher-safe grease filter
  • Cons:
    • May be expensive for some budgets
    • Only fits certain Panasonic microwave models

Customer Reviews about Panasonic Microwave Trim Kit NN-TK932S

Customers love the Panasonic Microwave Trim Kit NN-TK932S for its sleek and modern design, high-quality construction, and powerful ventilation system. Many customers have commented on how easy it is to install, with clear instructions and all necessary hardware included. However, some customers have noted that the trim kit is expensive and only fits certain Panasonic microwave models. Overall, customers are very satisfied with the Panasonic Microwave Trim Kit NN-TK932S and recommend it to anyone looking for a built-in solution for their Panasonic microwave.

Faqs

What is the purpose of the Panasonic NN-TK932S Microwave Trim Kit?

Panasonic Microwave Trim Kit NN-TK932S trim kit is designed to allow you to install a compatible Panasonic microwave into a wall or cabinet cutout for a built-in, seamless appearance in your kitchen.

Which Panasonic microwaves are compatible with the Panasonic Microwave Trim Kit NN-TK932S kit?

Panasonic Microwave Trim Kit NN-TK932S kit is compatible with specific Panasonic microwave models such as NN-SN966S, NN-SD966S, and NN-SN936S. Please refer to your microwave's user manual or Panasonic's official compatibility list.

What are the exact dimensions required for installing the Panasonic Microwave Trim Kit NN-TK932Skit?

Panasonic Microwave Trim Kit NN-TK932S kit requires a cabinet or wall cutout of approximately 27 inches wide, 16.5 inches high, and 20 inches deep. For precise measurements, consult the installation guide.

Is professional installation required for the Panasonic Microwave Trim Kit NN-TK932S kit, or can it be installed by a DIY enthusiast?

While Panasonic Microwave Trim Kit NN-TK932S possible for an experienced DIY enthusiast to install it following the detailed manual, professional installation is recommended to ensure proper fitting and to maintain the manufacturer's warranty.

How do I clean the Panasonic Microwave Trim Kit NN-TK932S?

The grease filter on the Panasonic Microwave Trim Kit NN-TK932S is removable and dishwasher-safe, making it easy to clean and maintain.

Will the Panasonic Microwave Trim Kit NN-TK932S kit secure the microwave in place during operation?

Obviously, the Panasonic Microwave Trim Kit NN-TK932S firmly secures the microwave to the wall or cabinet cutout, ensuring safe operation without movement.

What is the warranty on the Panasonic Microwave Trim Kit NN-TK932S?

The Panasonic Microwave Trim Kit NN-TK932S comes with a one-year limited warranty.

How loud is the Panasonic Microwave Trim Kit NN-TK932S?

The Panasonic Microwave Trim Kit NN-TK932S has a noise level of 6.5 sones.

What is the return policy for the Panasonic Microwave Trim Kit NN-TK932S?

Panasonic offers a 30-day money-back guarantee on the Microwave Trim Kit NN-TK932S, less shipping and handling fees.

Where can I buy the Panasonic Microwave Trim Kit NN-TK932S?

The Panasonic Microwave Trim Kit NN-TK932S is available for purchase online and in-store at select retailers.

SmartSet Clock Radio ER100103 Guide

Things to Check Before Buying a Used Refrigerator

Leave a Comment

Name

Email

Comment